Pucker me up!!

Comments

  1. Andrew Jenkins22 March 2017 at 19:58

    Looking great Henry, keep at it! And remember, be strategic with your hits :)

    ReplyDelete
    Replies
    1. Henry Wever22 March 2017 at 20:02

      Thanks for the advice Andrew, you're a legend!

      Delete
    2. Unknown22 March 2017 at 21:11

      No worries Henry thank you 🙏🏻

      Delete

Post a Comment

Popular posts from this blog

Assessment 2 : The Ferrari 250 GTO

Image
L T T S Assignment two required us to form into groups. These groups were organised to increase interdisciplinary communication within the course. My group consisted of four people including Gregory Brock, Hepeng Ouyang, Marco Lei and myself ( Henry Wever ), studying construction management, architecture x2 and landscape architecture respectively. A good mix The brief was as follows ‘students will create a scale template for a Ferrari 250 gto and then divide it into equal portions. As individuals they will create an aluminum skin to adhere to their portion of its contours.’ As we were only a group of four it was expressed that the entirety of the Ferrari was not needed to be completed as the marking was based on the portion that you were responsible for, however it was still a desire of our group to attempt to finish the Ferrari in its entirety. 1.      The first step was to create the template of the Ferrari. The initial program 123D...
Read more

Assessment 3 - Original Tutorials and Disciplinary Reflection

Image
Aim -   To create a torus (reverse curve).   What is a Torus (reverse curve)? - A torus is defined as a surface or solid formed by rotating a closed curve, especially a circle, about a line which lies in the same plane but does not intersect it (e.g. like a ring doughnut). What does torus (reverse curve) look like? What Materials will you need?   -        access to a workshop or tools that are normally found within such as mallets, dollies, shot bags,   metal cutters, English wheel, gullotine etc. -        Aluminum sheet metal -        Pens/markers -        Log piece -        Enthusiasm! Some key points before you begin 1.      Ensure you have enough metal to create the piece in which you desire, a torus will s...
Read more